this post was submitted on 22 Nov 2025
581 points (97.4% liked)
Technology
77058 readers
2409 users here now
This is a most excellent place for technology news and articles.
Our Rules
- Follow the lemmy.world rules.
- Only tech related news or articles.
- Be excellent to each other!
- Mod approved content bots can post up to 10 articles per day.
- Threads asking for personal tech support may be deleted.
- Politics threads may be removed.
- No memes allowed as posts, OK to post as comments.
- Only approved bots from the list below, this includes using AI responses and summaries. To ask if your bot can be added please contact a mod.
- Check for duplicates before posting, duplicates may be removed
- Accounts 7 days and younger will have their posts automatically removed.
Approved Bots
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
It is and it isn't. To use the onboard control to actuate the parking brake, yes, you have to use the paywalled software. But it's a simple motor. Positive and negative. If you disconnect the connector at the parking brake and use fused jumper leads to a 12v battery, you can cause the actuator to go forward or backwards. Make sure the parking brake isn't applied before doing anything, disconnect the cars battery, disconnect the p brake connector, jump the terminals once you figure out which polarity causes the retraction. Manually compress the caliper piston, replace the pads (and hopefully the rotors too). Pump the brake pedal as you would normally once everything is replaced, reconnect everything, and you're good to go. in my experience this doesn't work on ford but there's a service procedure that doesn't use a scanner to force the park brake into service mode. There's always a way around dumb stuff like this