@CarbonAlpine Amazing model. Did you publish anywhere? I'd like to print for a full size mock up horse I made.
roller
joined 2 years ago
@MissJinx there are a few but some are just rebadged versions of other slicers. Prusa/Orca and Slicer are two I have tried.
@MissJinx I've had issues with some slicers not coping with vase mode.
Did you try changing the vase mode settings?
Some models don't work so well on vase mode. Usually with steep overhangs.
You might try a different slicer?
@RegalPotoo @Wilshire good point. Release agents are used for casting concrete. They look to be oil and water mix so I'm guessing most plastics would be compatible.
Also has to be a clear path out for the print/concrete.
@FearTheCron @YourAvgDuckHead According to encyclopedia Britannica, I'd say a fairly reliable source, your out by a factor of 100. https://www.britannica.com/science/chromosome
A human blood cell is approx 10 micron long, according to this... https://www.ncbi.nlm.nih.gov/pmc/articles/PMC2998922/
Apologies for the pedantry, I couldn't help it.
@bdonvr you've probably heard this before...... But magnetic PEI build plate is the best adhesion I've had.
Used glass on my CR10S but it's night and day vs PEI on the ender 3 S1 plus.
Keeping it clean is key but copious quantity of IPA and a very light sand has worked so far.