this post was submitted on 10 Jul 2023
-1 points (0.0% liked)

Asklemmy

43722 readers
1315 users here now

A loosely moderated place to ask open-ended questions

Search asklemmy ๐Ÿ”

If your post meets the following criteria, it's welcome here!

  1. Open-ended question
  2. Not offensive: at this point, we do not have the bandwidth to moderate overtly political discussions. Assume best intent and be excellent to each other.
  3. Not regarding using or support for Lemmy: context, see the list of support communities and tools for finding communities below
  4. Not ad nauseam inducing: please make sure it is a question that would be new to most members
  5. An actual topic of discussion

Looking for support?

Looking for a community?

~Icon~ ~by~ ~@Double_A@discuss.tchncs.de~

founded 5 years ago
MODERATORS
 

So my relatively new s&w m&p15 won't cycle the action when shooting. The hammer will reset but the bolt wont move at all. This happens with several different ammos, both winchester 223 and winchester/ federal 556.

First thing i did was clean and oil it. No difference.

Then I checked the bolt seals and they are in good shape. When standing the bolt up on it's extractor side it doesn't move, but will with light pressure.

I figured something must be wrong with the gas tube so I blew some carb cleaner through the gas port in the action (the nipple that interfaces with the gas key on the bolt). I expected it to be blocked but the cc ran out the barrel unobstructed.

I covered the gas port (in picture) with a piece of masking tape when shooting and gas came out enough to discolor the tape but not blow a hole in it. I know that's not super scientific but nothing wrong with more info.

I honestly can't think of anything it might be. Any info helps, thanks.

no comments (yet)
sorted by: hot top controversial new old
there doesn't seem to be anything here