3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
I don't print TPU on a textured bed. I use the flat side of my build plate, which I also have coated with a giant sheet of Kapton/polyamide tape. Peeling the completed parts off of the smooth surface has never been an issue.
A word to the wise: Always run with a sheet of polyamide tape if you have a flat build plate. This will go a long way towards protecting the finish and flatness of your plate, and I have definitely saved myself a couple of times when having a Z offset that was too low and thusly crashing the nozzle only into the tape and not the surface of the expensive plate itself. You can apply adhesive and clean the tape's surface just the same as the PEI surface of your plate, but once it gets worn out or chewed up or otherwise no longer produces parts with a pretty underside, you can just peel it off and reapply. If you've already fucked up the surface on your plate you can also paper over this with a layer of tape which will smooth out small scratches, pock marks, and other imperfections.
And if you really need to employ the nuclear option to get a stuck part off of your bed (i.e. if you've printed something with a sticky filament such as TPU or PETG and happened to have your Z offset way too low) you can peel the tape off along with the part. The tape is unlikely to survive this process, but a pack of 12 sheets is only $20 or so.