this post was submitted on 18 Oct 2024
157 points (98.2% liked)
Asklemmy
43678 readers
1714 users here now
A loosely moderated place to ask open-ended questions
Search asklemmy ๐
If your post meets the following criteria, it's welcome here!
- Open-ended question
- Not offensive: at this point, we do not have the bandwidth to moderate overtly political discussions. Assume best intent and be excellent to each other.
- Not regarding using or support for Lemmy: context, see the list of support communities and tools for finding communities below
- Not ad nauseam inducing: please make sure it is a question that would be new to most members
- An actual topic of discussion
Looking for support?
Looking for a community?
- Lemmyverse: community search
- sub.rehab: maps old subreddits to fediverse options, marks official as such
- !lemmy411@lemmy.ca: a community for finding communities
~Icon~ ~by~ ~@Double_A@discuss.tchncs.de~
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I used to work at a new car dealership, I didn't have a whole lot of experience. I get a new truck in that the customer wants running boards installed on. I get it up on the lift and start working on it. I get one side loosely on and bend down to do something then the back of the truck falls off the lift and the sides land on the lift arms. For some dumb reason my instinct was to try to catch the truck. Fortunately I wasn't crushed. The problem was that the lift arms did not lock into position, the lift pads were round rubber pads which were pretty smooth and the truck frame had just been undercoated. The lift arms just decided to both slip inwards. They said it wasn't even the first time something like that had happened with that specific lift.
The damage was pretty bad because that running board that was loosely installed bent up the rocker panel. Both bed sides were damaged.