this post was submitted on 09 Jun 2024
653 points (97.5% liked)
Technology
59666 readers
2946 users here now
This is a most excellent place for technology news and articles.
Our Rules
- Follow the lemmy.world rules.
- Only tech related content.
- Be excellent to each another!
- Mod approved content bots can post up to 10 articles per day.
- Threads asking for personal tech support may be deleted.
- Politics threads may be removed.
- No memes allowed as posts, OK to post as comments.
- Only approved bots from the list below, to ask if your bot can be added please contact us.
- Check for duplicates before posting, duplicates may be removed
Approved Bots
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
The problem with LEDs isn't the bit that emits lights. It's the power supply, specifically the electrolytic capacitors. Good designs either use higher quality caps, or use designs that avoid electrolytic caps altogether. Either one takes a bit more money, but the market is always in a race to the bottom.
Long term, I think we should be avoiding traditional light fixtures entirely. It's better to have a lot of little lights spread over an area rather than a few point sources in the room. That gives us the opportunity to separate the power supply from the lights entirely, like LED strips do.
The LEDs will also fail from overheating. LED bulbs don't last long in fully enclosed fixtures that were designed for incandescent bulbs.
If the bulb starts flickering, that's usually a bond wire failure in an LED. When the LED heats up the bond wire loses connection and it will reconnect when it cools down again. The LEDs are in series, so if one fails, the entire bulb goes out. Flickering can also be caused by a capacitor failure in a switch mode supply, but most LED bulbs use linear regulators with a high voltage series string of LEDs now, which also increases the chance of a bond wire failure.
The early LED bulbs that cost a fortune had huge aluminum heat sinks to keep them cool. The few that I had all lasted until the LEDs got dim.
The newer designs that use very long, filament-attached LEDs in a large helium filled glass bulb also work quite well, even in a classical light fixture. The helium filling helps with cooling because helium has higher convective heat transfer than air.